Avata 2 would not enter manual mode

So I am in Portugal and I brought my drone family with me. I took the Avata 2 out today and took off in normal mode(no flat surface) when airborne I attempted to get to manual mode and the normal “put sticks here” display came up, I positioned the stick and got the two green dots but it would not enter manual mode?

Two points to consider my goggles needed a compass calibrate before takeoff and when I got home I did a quick test and before take off my goggles required a controller calibration. I calibrated and all worked normally again has anyone else seen similar?

There’s been a firmware update in the last couple of days, perhaps that’s got something to do with it?

I didn’t apply yet I will do though now, thank you

I’ve ignored updates (as usual) and was able to get in manual at the weekend

Granted I was in Doncaster not abroad :person_shrugging: