Not sure if anyone else has been having this issue but
Been getting no picture through to my smart controller upon boot up of controller and M2P, initially putting in a different sd card worked but then not.
Now formatted internal drive worked.
But turning off controller rather than drone worked as well
I had it once after updating the firmware did a reset of the controller and it has not happened again.
yeah not here, updated software at the start of the week and still doing it, may try factory reset and then software update again
Did a factory reset cure the problem ??
Quite interested in this subject as I’m considering getting a Smart Controller but have seen numerous posts on various forums but none seem to give a definitive fix.
sorry @Jhdee haven’t had the chance yet, probably over the weekend, will keep you posted