Signals and latency

Racing Quads, Self-builds & FPV
1

Bonjourno,

Been flying a lot now with my Mob8.
Using the boxer elrs radio and dji n3 goggles.

The quad doesn’t get to far away from me, in open space and I get signal loss messages in my OSD.

This could be a can of worms im opening, but would love to hear input.

Essentially, what would I focus on to get the signal loss better?

I just get ‘RSSI low’ and ‘signal loss’ messages.

Settings within edgeTX? New antennors? Just the nature of the beast with that particular drone?
Im waiting for a new AIO board from BetaFPV and ill get my pavo20 II up in the air and see whether that does the same thing.

Any input would be amazing.

Got to repair the broken frame on the mob8 after a crash.. apprently the break is very common, but the signal problems need reviewing as well.

TIA

2

What ELRS settings are you using (frequency and power)?

Was it happening since the beginning or only started later?

Have you checked the antenna connector is well seated / antenna not damaged - and is clear of the board?

1 Like