Simple question, these little wood screws for screwing into the wooden racks in planes… What are they size wise? Quite small? Something not yet in my screw box 
Might nip to town and see if the final remaining handy household place at lunchtime… Busy 3d printing bits 
The experienced @Steviegeek or @notascooby probably answer this in seconds
Maybe not ideal, but I bought a box of these for similar work.
Looking at these, but they a “one size” order, not a mix like yours…
https://www.amazon.co.uk/sourcing-map-Phillips-Stainless-Fasteners/dp/B07Q365898
The mix means you can use them for all sorts of stuff… and guess the right size.
Also when one strips a hole, you just put a bigger one in.
Yeah exactly. like having a selection, though like with my M2/3/4 hex sets you run out one ages before the others, oh and heat shrink
I like the ones I linked have the “washer in”
those look nice
You probably can’t wait till the weekend but I can give you a handful 
Oh I knew you’d offer that, as you’re a superstar, but how on earth will it fly at 8:00 on Saturday morning, if I don’t get the screws until 8:10 Saturday morning 
Thanks mate, ordered the last bit from above in the end (plus a few extra bits and bobs, the accessories in this hobby add up!)
Also just discovered, that despite being on a skid… The bloody FC is glued in… ergh. fun times soldering in foam…
but it would fly five minutes after we arrive 
do you want an early start then ???
Well need to check whether I can make, don’t plan around me. Though Karl said he’d need to leave around 12, and tbh I would be close to that.
It’s unlikely I’ll have the T1 ready by then, but will give it a go
