Once you’ve downloaded the NazaM_V2 Assistant you need to go to this tab to ensure that the controls on your Devo10 map correctly to the controls shown. You just need to move the sticks, switches, and sliders/knobs,
The command sticks are self explanatory, X1 corresponds to the Gimbal control and X2 is the IOC control (Course Lock. Home Lock) this one I usually disable as I never use this function other than to initiate a compass calibration.
The Gimbal function also needs to be enabled in this software.
At the top is the option to switch the gimbal control on or off, set it to on.
F1 and F2 are the physical outputs from the Naza controller to the the Gimbal, as you can see F2 is used is used for Pitch but is only of any significance if using anything other than the Zenmuse as this has it’s own controller and is connected to the Naza Port Hub. But still you can set the default power on position, amount of travel, and speed of travel, from this TAB.
For adjustments specific to the Zenmuse H3-2D gimbal you need to access this TAB.
You probably will not need to adjust the gains but if you do the instructions are on the left panel.
If you have any other questions don’t hesitate to shout out. I’ve not used a Devo10 but the mixer options are probably not that much different from other digital radios.
Nidge,