I assume this will have been asked hundreds of times before so sorry if I’m in the wrong place.
I have been recording some footage on the inspire 1, I have only ever shot in Automatic mode as I am not that clued up on manual mode.
I was filming today and it was an overcast/ rainy at time. I was filming military training so unfortunately I cannot post for obvious reasons. But the footage was in 4K but played back it it really pixilated and grainy and generally poor quality.
I had similar with some of the stills being a little grainy when I zoomed in…
I will be shooting some more tomorrow and would like it to look perfect as there is a possibility it could be used as an Army wide promo video, andost of the stuff shot today is unusable.
Any advice or guidance is greatly appreciated as I have said so many times before I’m new
If it was dull and you were shooting in auto then you had no control over ISO, shutter speed or aperture. If the algorithm decided that raisng the ISO was the way to ensure correct exposure then that could be an explanation for the “grain”.
The higher the ISO the noisier the image - easily seen in areas of continuous tone such as overcast skies. To avoid it is a matter of adjusting shutter and aperture to allow the maximum light through the lens - with compromises to image blur and depth of field obviously.
Your editing software may well have a boise reduction option you can use to correct some of the problem.
That would have been my guess. I gave up using Auto mode after some great video opportunities got wrecked on auto and I couldn’t tell until I was home .
Low iso, careful appurture settings and filters usually get great results.
It is possible to force the transfer of the 4k video to your device using the app … after the flight, but …
for 4k video it takes a while,
the drone needs to be powered up … using the batteries and resulting in more recharging than is necessary,
They can also be copied direct to a computer via the USB cable by connecting it to the drone, but …
whilst quicker than copying via the app - this still depletes your batteries since the drone has to be switched on.
For me, it’s simple. My drone batteries are for flying - not for copying data. So I always remove the card and put it in my laptop, or my phone’s SD Card reader.