Hi all, today I managed to lend some very good scales and weighed the NT8 lens 1.1g so I made a counter weight of 1g for the rear of the gimbal the counter weight was a bit lighter to allow for the glue I used, fitted the lens and counter weight, the Mavic Pro spit it’s dummy out “large load on gimbal”
I removed the lens and started it up again with the weight still on the back but no lens, all fine so I did a gimbal reset 100% fine with the weight on?? what’s going on? could the darker lens be telling the software there is a problem? If I put the lens on after it boots up and says ready to go, all is fine and I can do a gimbal reset with both on? But this is a messy way of using a NT lens having to put it on after start up?
I don’t know what to do next! I just don’t understand the gimbals requirements!!