RC Pro Controller and DJI RC/ RC 2 with FCC hack by Sincoder

clinkadink · 28 September 2022 14:07

Just applied FCC to my RC Pro which was provided by Sincoder. No Teamviewer needed, I did it myself in about 10 minutes.

[1] Message Sincoder on Telegram, +86 13590379508, say you would like FCC enabled on RC Pro
[2] He will confirm your on Windows 10 or 11 and then send you a ZIP file to extract, pw is “dji”

[3] The ZIP includes a “readme.txt” which has to be translated from Chinese to English (see below)

Readme.txt (translated)

First install DJI software on the computer, download address
DJI Assistant 2 (Consumer Drones Series) - Download Center - DJI
After installation, turn on the remote control and connect it to the computer to ensure that it can connect to the official software
Check the firmware of the remote control in the official software and upgrade to the latest firmware
Close the official software
Put the registration code in pass.txt
Open djifcc.exe and start running, the first run is to register the software, the second and third time are to install FCC, at least three times,
If it fails or gets stuck, you can try to run it again, and the software can run repeatedly
If you want to uninstall FCC, click on the remote control settings, delete all data, and restore the factory settings.

[3] Download and install DJI Assistant (if you don’t already have it), connect the RC Pro, and ensure you have the latest firmware installed, and then close, but keep the RC Pro connected via USB to the PC

[4] He supplies a PayPal link to pay him $40, once paid, he supplies a password for the hack
[5] Copy and paste the password into “pass.txt” and save
[6] Run “djifcc.exe” to register the serial number

[7] If successful, the “pass.txt” file will automatically be deleted from the unzipped folder
[8] Now rerun “djifcc.exe” again to apply the hack, you may need to do this a couple of times until you see “FCC patch installed successfully”