Hey Wayne @SparkyFPV Yes to be fair to Flytron they did actually supply those 3m Velcro pads with each of the strobes but I was looking for something a bit more substantial.
I’ll mention Grey Arrows when he gets back to me.
Andy 
1 Like
Are you sure Guy, no problem printing 4 in Orange. I’ll put the grey one in as well for a spare.
2 Likes
Entirely up to you.
1 Like
Hi Andy,
Thanks, I just got your message through eBay. I’m afraid I stopped at the Air 2, didn’t make any for the Air 3.
In fact, I think I’ll stop them all, after you pay eBay and packing and the postage, there’s nothing much in it.
Hope you get sorted.
Cheers
Andrew
2 Likes
@ash2020 Ok Andrew, it’s a shame but I totally understand. My quest continues
Andy 
Ash would you consider sharing the files 
2 Likes
They are stifling most small sellers. Unless you are selling loads and fast there’s very little profit.
Actually Wayne, while there’s a little life left, I think I’ll keep selling them. I may do a set for the Air 3 soon.
1 Like
Andy, if you can get the measurements of the arms where you want to mount the strobes I could modify these or others that are freely available to fit
https://www.printables.com/model/444960-dji-minimini-2-strobon-cree-standalone-holder
1 Like
Sure thing Wayne. I’ll send you the dimensions when I get my hands on one. (I love Amazon).
1 Like
Hey Wayne @SparkyFPV That’s a very kind offer sir. If I can borrow a micrometer from someone I will try to compile some dimensions for the clips. Having said that, it looks like Andrew @ash2020 may be able send you the details too! I will have a look at it though, but I must admit I’ve not completely ruled out Velcro.
Andy 
1 Like
Hi Guy @speedracer66 just started the 1st print in orange.
Will give you a shout when all 3 have been completed.
1 Like
Thanks!
1 Like
Fantastic - thank you!
1 Like
No Problem. 
Unusual request.
Anyone can print in two materials ?
Both of which are TPU ?
Holder for a medallion for use on cruise. Works in TPU - needs flex:-
Would be nice in two TPU Colours.
18g of filament, but more as lots of colour changing. Happy to pay materials postage etc.
If works I can see myself getting a multi-material printer.
Bambu AMS won’t do TPU so colour swap is manual. That’d be a right pain. Don’t think get a bambu for multi colour TPU mate have to manually load TPUs
1 Like
Yes in TPU it would need manual changing and would take an age, we are talking about changing every single pass, nightmare 
Job sorted 
2 Likes