Hi.
Has anyone seen any patterns for Propeller Bumpers for DJI NEO?
I’ve looked everywhere on the Tinternet and their not even for sale on Ali Express yet
1 Like
All I could find at the mo
1 Like
Ken is selling them on his Etsy site:
https://www.etsy.com/uk/listing/1791423859/dji-neo-snug-riders
But I’m not sure that helps you Jason mate 
2 Likes
I just made a set for GoFilm20 in OpenScad
Could work for neo
The module is (roughly) parametric
1 Like
I will print those below I found tomorrow in TPU let you know how they turn out
1 Like
1 Like
These printed pretty well, a lot of stringing but fit well, just ordered a dayglo green TPU and a filament dryer, see what they look like then, but they are a good and easy fit so far
2 Likes
Why would you need them on that drone ? just wandering
Higher speeds, lower flying more crashes due to the nature of the beast
Camera ship this is not.
Also will soften the blow if it hits you in the face
Myself and @TheBinman have the medal for that 
5 Likes
Ahh right , I see ,yes don’t need the thing smacking you in the face , yea that would hurt with props or just the plasic bumper .
So basically its a safe remote controlled flying thing , gotcha …I think 
I printed these off in tpu but they made the Neo unstable
Printed them in petg and and it was okay but still wasn’t very secure
1 Like
Because of the gaps around the edges, do you know? 
Was you sat on the porcelain throne when you took that pic
1 Like
Yes
3 Likes
You need to take it out of follow me mode🙄
4 Likes